Help keep your flock’s drinking water available through freezing weather with this 28W chicken waterer heater base. Designed for compatible round poultry drinkers, the insulated base directs gentle warmth upward while adjustable clamps help hold the waterer in place. It is a practical winter option for chicken keepers who already have a suitable plastic or metal drinker.
Heated Base for Compatible Chicken Waterers
The three movable yellow clamps adjust around round plastic or metal poultry drinkers up to 12.6 inches (32 cm) in diameter. Measure the lower portion of your drinker before ordering and make sure it can sit centered and stable on the 30 cm heater base. Waterer shape matters as well as diameter, so this product should not be treated as a universal-fit heater.
For smaller drinkers with a raised bottom, the clamps can be positioned with the short ends facing inward as shown in the product instructions. The drinker is sold separately.
Low-Wattage, Insulated Winter Design
This poultry drinker heater uses 28 watts of power and a low-voltage 24V DC connection on the heater side. A 15 mm layer of polyurethane insulation helps direct warmth toward the bottom of the drinker instead of allowing it to dissipate downward. After connection, allow up to approximately 15 minutes for the base to warm.
The heater helps prevent water from freezing to approximately -13°F (-25°C) under suitable conditions. Actual performance depends on air temperature, wind, shelter, water volume, drinker material, drinker shape, and placement. Wind can reduce heating effectiveness, so check the water regularly during severe weather rather than assuming it will remain ice-free in every environment.
For more ways to manage water, shelter, ventilation, and flock health in freezing weather, read our winter chicken care tips.
How to Set Up the Poultry Drinker Heater Base
- Choose a protected location. Place the base under a roof or shelter where it will remain dry and protected from wind.
- Use a stable surface. Set the heater on an elevated, flat, firm surface such as a tile. Do not place it where flooding, spilled water, or wet bedding can reach the electrical components.
- Adjust the three clamps. Position the yellow holders for the shape and diameter of the drinker, then center the drinker securely on the base.
- Keep power components dry. Place the power adapter and electrical connection in a dry area out of reach of chickens and other animals.
- Inspect and monitor. Check the cable, connection, waterer stability, water level, and surrounding area before use and throughout freezing weather.
For a broader seasonal checklist, follow our guide to winterizing your chickens and coop.
Chicken Waterer Heater Base Specifications
- Model: DBV30-USA
- Product type: Heated base for compatible poultry drinkers
- Power: 28 watts
- Heater-side connection: 24V DC
- Base diameter: 30 cm
- Maximum compatible drinker diameter: 12.6 inches (32 cm)
- Compatible drinker materials: Plastic or metal
- Adjustable holders: Three clamps
- Insulation: 15 mm polyurethane
- Approximate supported cold-weather performance: Down to -13°F (-25°C) under suitable sheltered conditions
- Warm-up time: Up to approximately 15 minutes
- Manufacturer: Olba
- Country of manufacture: Netherlands
Important Use and Safety Information
- Use only for warming a compatible poultry drinker during freezing conditions.
- Use in a covered, dry, wind-sheltered location.
- The heater base is not waterproof. Do not flood, immerse, or submerge it.
- Keep the adapter and every electrical connection dry and out of animals’ reach.
- Do not cut, modify, crush, or use a damaged cable, adapter, or heater.
- Disconnect power before cleaning, moving, or inspecting the unit.
- Follow the supplied instructions and check your flock’s water daily during cold weather.
A Focused Solution for Winter Poultry Water
This is a heated waterer base, not an immersion deicer and not a complete poultry drinker. Its low-wattage insulated design is intended to warm the bottom of a compatible waterer in a sheltered setup. Pair it with a correctly sized drinker, protect all electrical parts from moisture, and continue normal daily water checks throughout the winter.
Chicken Waterer Heater Base: Frequently Asked Questions
What size chicken waterer fits this heated base?
The three adjustable clamps accommodate compatible round plastic or metal poultry drinkers up to 12.6 inches (32 cm) in diameter. Measure the lower portion of the drinker and consider its base shape before ordering because the heater is not universal-fit.
How cold can the chicken waterer heater base operate?
The manufacturer rates it to help prevent freezing to approximately minus 13 degrees F (minus 25 degrees C) under suitable conditions. Air temperature, wind, shelter, water volume, drinker material, shape, and placement all affect performance, so check the water regularly during severe weather.
How much electricity does the poultry drinker heater use?
The heater uses 28 watts. Its heater-side connection operates at low-voltage 24V DC, and 15 mm polyurethane insulation helps direct warmth upward toward the drinker. Use only the adapter and connection specified for this model.
Can I use the heater base with a plastic poultry waterer?
Yes. It is designed for compatible round plastic or metal drinkers up to 12.6 inches (32 cm) in diameter. The waterer must sit centered and stable on the 30 cm base with the clamps properly positioned.
Where should I place the heated chicken waterer base?
Place it on an elevated, flat, firm surface such as a tile in a covered, dry, wind-sheltered location. Keep the power adapter and all electrical connections dry and out of reach of chickens and other animals.
Is the poultry waterer heater base waterproof?
No. The base is not waterproof and must not be flooded, immersed, or submerged. Protect it from spilled water, wet bedding, rain, and snow, and keep the adapter and electrical connections dry.
How long does the waterer heater base take to warm up?
Allow up to approximately 15 minutes for the base to warm after it is connected. It is designed to help prevent freezing in a suitable sheltered setup; it should not be expected to thaw a large volume of frozen water immediately.
Is a poultry drinker included with the heated base?
No. This product is the heated base for use with a separate compatible poultry drinker. It is not a complete waterer and is not an immersion-style deicer.
